10 Feb

Basic Manual

Detect - Config - Select - Mod and Repeat

It’s time that we should explain some basics steps of configuration for our customers and this is mostly how it is done .

1 - Detect

Detecting as the first step of the process

We just have to make sure that the NAND IC inside the socket well placed .

2- Config

So in case there is no error with detecting thenand we can go to step 2 to start configuration for the NAND

3- Select

Select the NAND Model from the list That Match with your NAND

4- Mod

This is the critical part customers usually confused.

So nothing wrong with the loading pre-configured configurations but in this part you should add your device information fill in the UI and as a final step .

Write Boot !

Done..

Leave a Reply

Your email address will not be published. Required fields are marked *